Speaking of carbon filter, there are many types of carbon filters, such as pour-through filters, faucet-attached filters, specialty filters and Line by-pass and stationary AHU Air Filters. Therefore the Carbon Filter maintenance is different according to these types. However, most carbon filter needs to have the carbon changed periodically. If else, they need to be cleaned in a regular time. Today we mainly talk about how to clean carbon filter.
In most of the cases, the cleaning procedure must be conducted after regular intervals at least after every month. Regular usage leads to the deposition of thick layers of wastes or dust particles and sometimes the sticky wastes also create a smelly odor. One thing I have to charity is cleaning will not affect the adsorption capacity of carbon filter because it is based on the oxidation process used to produce the carbon. Filters should be changed on schedule to avoid contamination breakthrough. The filter material or cartridge should be replaced if left unused for an extended period of time. Ok, now let’s see the carbon filter maintenance.
For carbon air filters, wipe debris from the outside of the filter using a dry sponge or your hand. Carbon chemical filters are often similar to lint traps on clothes dryers. Then gather lint from a carbon filter in the same manner as you would when cleaning a lint trap. During the progress, never wet a carbon air filter. Next, you can tap the carbon air filter on a solid surface to loosen dust and dirt trapped inside. Then grasp the carbon air filter firmly and wave it through the air vigorously. Wave the filter until you can no longer see dust coming from the filter. At this time, you can run the sponge over the outside of the filter to remove any dust or dirt on the frame.
For carbon water filters, hold the carbon water filter under warm, running water for approximately one minute to loosen and rinse any outside debris. Debris on carbon Stainless steel mesh grease filters must generally be removed by picking off small pieces. Squirt a dime-sized dollop of liquid detergent on a sponge. Wet the sponge and rub its two ends together to create suds. Rub the sponge over the carbon water filter using a gentle, circular motion. Doing so will remove film, residue or debris. Flip over the carbon water filter. Rub the sponge over the opposite side to remove any film, residue or debris. Finally, rinse the carbon water filter by holding it under warm, running water until the water runs clear.
After learning these common ways of carbon filter maintenance, you can maintain your carbon filter more experienced. If you are in need of carbon filter, you can visit www.hefilter.com for further information.
