Maybe the grease can be one of the most troublesome forms of waste in kitchen. In order to remove the grease along with many other dusts the air, many people choose the grease filter. Unfortunately, installing a Aluminum mesh grease filter takes a bit of preparation, and can only be done by those with some previous experience in plumbing. Here we provide the way of how to use Grease Filters.
Firstly, locate the proper position for the grease trap. Usually, the best place is underneath the sink from which the grease drains, but you can place the trap anywhere you like so long as it is nearby and below the level of the grease's drain. In addition, you should use the top-right corner outlet of the grease trap to install a vent. Screw a 90-degree elbow onto the trap, direct it facing up and add a "T" fitting to the end, attaching the shaft of the "T" to the elbow, and leaving the crossing ends open to the air. This will ensure that air can flow in and out of the trap, allowing the grease to vent its moisture and solidify properly.
What's more, redirect the sink and/or drain pipes to connect to the top-left corner of the grease trap. Make sure that you use screw fittings with no hubs. You may need to add several elbow fittings and straight piping. And then redirect the open end of the sink/drain pipes to connect to the bottom right corner of the grease trap. You can use any combination of no-hub screw-in pipe fittings as before, but make sure that the level of the piping does not rise to a level above the exit from the grease trap.
Here got the last step of how to use Grease Filters. Install the clean-out tee in the grease trap's outlet. Open the lid on the grease trap, and insert the "X" end of the tee into the outlet. This will allow you to easily clear any grease clogs from the grease trap simply by turning and/or temporarily removing the clean-out tee.
During the progress of how to use Grease Filters, you need to clean out your grease trap at least once a month, perhaps even more depending upon how often you drain grease through it. Diligent maintenance of your trap will ensure that it does not fail at an inopportune time. Although some local traditions recommend burning grease as a means of disposal, this is not only dangerous but is also usually illegal by state and city ordinance laws. Contact your local waste disposal office for information on proper grease disposal.
After reading the introduction of how to use Grease Pre Filters above, we believe you will benefit a lot from greaser filter in the later days. If you are in need of grease filter, you can visit www.hefilter.com for further information.
