How to Correctly Install Filter Element

Position:Home > News > Industry News > How to Correctly Install Filter Element

How to Correctly Install Filter Element

Source:http://www.hefilter.comStartTime:2015-04-13Hits:

The air which blows into your element's passenger cabin will be cleaned through the HVAC vents and defrosters by cabin Air filters. They filter dust and dirt and keep the inside of your car nice and clean. But most people don't know how to install filter element. Here are instructions.

First step is to open the glove box on the passenger side and take everything out. Next, the sides of the glove box door need to be squeezed together to unlock these stoppers from the tracks. The sides have plastic stoppers molded onto them. And it makes the door slide smoothly during opening and holding the door in place when it's fully open. This leads you to drop the entire glove box assembly forward and down. What's more, check the cavity behind the glove box area. On the top right side, you'll see a large, black, plastic compartment as one of your replacement filters. The compartment has a little removable panel about the same size. To remove this panel, please putts plastic tab and lift it off. After that, pull on the black plastic object to just hide it behind this removable board.

Once you pull it out most of the way, getting it the rest of the way out, you may have to maneuver it around the dash assembly a little bit. Furthermore, you need to remove the second filter, and it is located just to the right of where the first filter was. To finish it, seize the left side of the right side filter and it should be visible through the opening. Then slide it to the left so that it is in the same position as the left filter was and pull the Filter out through the opening as the first one you have done. In addition, you ought to insert both of the new filters just like the arrangement of the old ones. Put one in first, slide it over to the right, and then insert the second one. When both filters are in place, you can replace the removable panel. Last but not least, the step is lifting it up gently squeezing the sides together and pushing it all the way closed to put the glove box back in place. Open and close it again just to make sure it's properly seated on its tracks.

If you live in a very dusty, dirty or sandy area, you will need to replace these filters much more frequently than if you follow paved roads and highways. The instructions of how to install Air Filter Element are very useful. Hope it will really help you to learn how to install filter element. For more information, please visit the website through the link www.hefilter.com.