Grease Filters Make Everything Clean

Position：Home > News > Industry News > Grease Filters Make Everything Clean

Grease Filters Make Everything Clean

Source：http://www.hefilter.comStartTime：2015-08-06Hits：
Grease filter has many advantages apart from simple Grease Filters working condition. First, the Grease Filter plate combined with high oil arrest low pressure loss. It comes standard with a protective film on the frame and filter mat does not extend the disintegration of the metal layer was washed. In addition, its multi-layered structure increases the rigidity of the panel and has a knitted wire-type water filters, which can be dangerous particles found there is no chance of broken grid. Last but not least, in order to adapt to different conditions in terms of fat content of the discharged air, both washable and disposable grease filters. Stock sizes are available, custom sizes to order. Handles and drainage holes are available.

To select the right Grease Filters, you should follow the suggestions below:
1. Filtration should meet predetermined requirements.
2. To maintain a sufficient flow capacity in a long time.
3. Filter having sufficient strength, without being damaged by the action of hydraulic pressure.
4. Filter good corrosion resistance, can be sustained in a predetermined temperature.
5. Filter cleaning or replacement is simple.
Thus, the Grease Filters should be based on the technical requirements of the hydraulic system, by filtering accuracy, flow capacity, operating pressure, fluid viscosity, temperature and other conditions of the model selected.

Grease Filters working condition should be ensured to be clean. To install filter installation position, there are five choices:
1. To be installed at the suction port of the pump. The suction pump is usually mounted pavement type filter. Its purpose is to filter out larger particles of impurities, to protect the pump, in addition to filtering the oil filter should be more than twice the volume flow rate of the pump. The pressure loss is less than 0.02MPa.
2. Mounted on the outlet of the pump oil on the road. The purpose here is to install filter used to filter out possible intrusion of valves and other components of pollutants. Accuracy of its filter should be 11 ~ 16μm, oil on the road and can withstand the influence of work pressure, the pressure drop should be less than 0.3MPa. At the same time the safety valve should be installed to prevent the filter clogging back to oil on the road
3. Installed in the system: This mounting an indirect filtration. Usually connected with the filter and install a back-pressure valve, when the filter is clogged the pressure reaches a certain value, the back pressure valve opens.
4. Installed in the system branch oil on the road.
5. Separate filtration system: the system can be designed for a large hydraulic pump and the Pre Filter to form an independent filter circuit.

If you are in need learning other Grease Filters working condition, you can visit www.hefilter.com for further information.

Prev page： How to Clean Industrial Filter Cartridges Next page：Simple Grease Filters Working Principle

Related News